ITC-308- WIFI device showing as heating when cooling

[Tania]

Hello,
Please understand that ITC-308-WIFI determines the output switch based on the probe reading and settings.
If the target temperature is set to 36F, ITC-308-WIFI shows heating at the current temperature of 31F, this may be because the temperature has reached the heating turn-on value (TS-HD), or the special mode has been triggered.
Please refer to:

Q&A: How does ITC-308WIFI work?

ITC-308WIFI has a special temperature mode and a normal temperature mode. The trigger conditions for the special temperature mode are: Enter the setting mode through the SET key then exit. Enter the setting mode through the app then exit. In the special temperature mode, ITC-308WIFI will ignore the settings of HD (Heating hysteresis temperature) and CD (Cooling back temperature) and turn on the heating/cooling output. It will not enter the normal mode until the temperature reaches the SV tar…

Please do not change the settings and let it run for 2-3 cycles. When the temperature reaches the cooling turn-on value (TS+CD), will it work as set?
Regarding the alarm settings, please note that after the settings are completed, please click the ‘return’ icon in the upper left of the app to exit and save the settings. Please do not use the original return button on the phone to exit the settings, otherwise it will not save the settings.