# Itc-308-wifi heating and cooling

**URL:** <https://community.inkbird.com/t/itc-308-wifi-heating-and-cooling/344>\
**Category:** Uncategorized\
**Created:** [February 17, 2022, 7:53pm UTC](https://community.inkbird.com/t/itc-308-wifi-heating-and-cooling/344 "2022-02-17T19:53:42Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![dannoz](https://avatars.discourse-cdn.com/v4/letter/d/7bcc69/32.png) [@dannoz](https://community.inkbird.com/u/dannoz)\
**Post date:** [February 17, 2022, 7:53pm UTC](https://community.inkbird.com/t/itc-308-wifi-heating-and-cooling/344/1 "2022-02-17T19:53:42Z")

</div>

Regardless of settings this device activates the heating or cooling outlet. Is there a way above the set temperature the cooling circuit will not activate until the temperature rises a certain amount? I’ve tried setting the “cooling back Temperature” setting without success.

Please advise.

---

<div class="post-metadata">

**Author:** ![Tania](https://yyz1.discourse-cdn.com/flex031/user_avatar/community.inkbird.com/tania/32/88_2.png) [@Tania](https://community.inkbird.com/u/Tania)\
**Post date:** [February 18, 2022, 2:02am UTC](https://community.inkbird.com/t/itc-308-wifi-heating-and-cooling/344/2 "2022-02-18T02:02:27Z")

</div>

Hello,  
Please understand that after the ITC-308WIFI is set up and exits the setting mode, it will trigger a special temperature mode.  
Please refer to this post:

> [@Q&A: How does ITC-308WIFI work?](https://community.inkbird.com/t/q-a-how-does-itc-308wifi-work/151):
>
> ITC-308WIFI has a special temperature mode and a normal temperature mode. The trigger conditions for the special temperature mode are: Enter the setting mode through the SET key then exit. Enter the setting mode through the app then exit. In the special temperature mode, ITC-308WIFI will ignore the settings of HD (Heating hysteresis temperature) and CD (Cooling back temperature) and turn on the heating/cooling output. It will not enter the normal mode until the temperature reaches the SV tar…

---

<div class="post-metadata">

**Author:** ![User\_1686081307709](https://avatars.discourse-cdn.com/v4/letter/u/a88e57/32.png) [@User\_1686081307709](https://community.inkbird.com/u/User_1686081307709)\
**Post date:** [June 9, 2023, 10:41pm UTC](https://community.inkbird.com/t/itc-308-wifi-heating-and-cooling/344/3 "2023-06-09T22:41:36Z")

</div>

this is confusing. how the h do you get out of this special temperature mode???  
i have wasted hours trying to figure out what is going on.  
how do i reset the inkbird and start over. what brainiac thought up this specail mode. r u trying to ruin a freezer full of food? seriously i am a bit upset. please give me detailed instructions on how this is suppose to work. i have two other non wifi models and they work fine. and don’t just reprint what is above cause it does not communicate