# Inkbird itc100 manual mode

**URL:** <https://community.inkbird.com/t/inkbird-itc100-manual-mode/166451>\
**Category:** Questions & Answers\
**Created:** [February 6, 2025, 1:32pm UTC](https://community.inkbird.com/t/inkbird-itc100-manual-mode/166451 "2025-02-06T13:32:20Z")\
**Posts on this page:** 3\
**Page:** 1

<div class="post-metadata">

**Author:** ![av43056](https://avatars.discourse-cdn.com/v4/letter/a/c2a13f/32.png) [@av43056](https://community.inkbird.com/u/av43056)\
**Post date:** [February 6, 2025, 1:32pm UTC](https://community.inkbird.com/t/inkbird-itc100-manual-mode/166451/1 "2025-02-06T13:32:20Z")

</div>

Hi, I have an inkbird itc100vh and I am running it in Manual mode… does this mode get affected by the measured temperature or not?  
I mean, I set the percentage of the output to 50%, and Ctl time to 4 seconds, and the temperature to 20°C, in Manual mode… the measured temperature is 15°C, and the controller is working 2 secs and does not work 2 secs which is good and expected… but when the desired temperature is achieved (20°C), the controller still works the same… I would expect it to stop working when the temperature is reached…  
Thanks

---

<div class="post-metadata">

**Author:** ![Tania](https://yyz1.discourse-cdn.com/flex031/user_avatar/community.inkbird.com/tania/32/88_2.png) [@Tania](https://community.inkbird.com/u/Tania)\
**Post date:** [February 10, 2025, 11:14am UTC](https://community.inkbird.com/t/inkbird-itc100-manual-mode/166451/2 "2025-02-10T11:14:28Z")

</div>

Hello,  
Sorry, if in manual mode, it works according to the manually set output %, it will not stop the output according to the target temperature.

---

<div class="post-metadata">

**Author:** ![av43056](https://avatars.discourse-cdn.com/v4/letter/a/c2a13f/32.png) [@av43056](https://community.inkbird.com/u/av43056)\
**Post date:** [February 10, 2025, 11:31am UTC](https://community.inkbird.com/t/inkbird-itc100-manual-mode/166451/3 "2025-02-10T11:31:26Z")

</div>

Ok, thank you very much…